Every piston-driven concrete pump needs a valve that redirects flow from the hopper into the delivery line as its two material cylinders alternate between filling and discharging. Two designs are used in the market: the S-tube, an S-shaped pipe that swings between the cylinders, and the Rock Valve, a pivoting gate mechanism.

In an S-tube system, two material cylinders are linked to hydraulic drive cylinders that cycle alternately. As one material cylinder retracts, it draws concrete in from the hopper; at full retraction, a signal shifts the S-tube to align with the now-loaded cylinder while the drive cylinders reverse direction. The concrete piston then pushes material through the S-tube and into the delivery pipe. This handover between cylinders happens continuously, so the pump maintains an uninterrupted flow of material through the line. Reverse pumping is also possible: the system can link the suction stroke to the S-tube valve so the piston draws concrete back out of the line into the hopper.

The Rock Valve operates as a pivoting, rocking mechanism. Its key operating principle is a wide feed opening: concrete wears against other concrete inside the valve body rather than grinding directly against a bent pipe wall. A pressure spring under the cutting ring keeps equal pressure on the cutting point so the seal does not separate under load while shifting.

Neither valve operates on its own. In a typical concrete pump, the main hydraulic circuit drives the material cylinders using a variable-displacement axial piston pump of swashplate design; tilting the swashplate changes piston stroke length and therefore output flow. A separate S-tube shift circuit controls the valve's movement between cylinders, and an auxiliary circuit runs the agitator and other support equipment. Because wear plates, cutting rings and seals in both S-tube and Rock Valve systems are consumable, replacement intervals tend to track total pumped volume and mix abrasiveness.